The first thing to understand is that there are two main ways to boot Windows on a Mac: The first is by running Windows while in the Mac OS. This process is is known as virtualization and the two main products that allow you to run Windows ...

You turn on the PC, it goes through the POST, then you get the error "Invalid Disk. Replace the disk and and then hit any key." First, check your floppy drive. Is there a floppy disk in the drive? Remove it and hit a key on your keyboard and see ...

You turned the system on, it went through the POST process, but then it stops with an error message "Missing Operating System". This means that the drive it is trying to boot from has no operating system installed on it. To make the drive bootable, boot with a floppy disk ...

If you get beep errors, you should try to think what happened right before they started. Did you add a new piece of hardware? If so, it might be faulty or not installed right. Remove it, then try again. If everything is fine without the hardware, try to reinstall and ...

Your PC powers up correctly, it passes the POST, all drives are detected correctly, but Windows does not load automatically. Instead you see an error message about a problem with your registry. This can happen either when the registry was corrupted by a bad software installation, or if one of ...

Start with the power. Is the power cable plugged in correctly into a UPS, surge protector, power strip, or wall outlet? Is the wall outlet where the power comes from controlled by a wall switch that was turned off accidentally? Is the power strip turned on? Is the light on ...

http://www.apple.com/macosx/bootcamp/ Changes in Boot Camp 1.2 beta Boot Camp 1.2 beta contains several updates and is intended for all new and previous Boot Camp beta users. Boot Camp 1.2 beta includes: Support for Windows Vista (32-bit) Updated drivers, including but not limited to trackpad, AppleTime (synch), audio, graphics, modem, iSight camera Support the Apple Remote (works ...